If you DID connect the Neutral Wire: Move the safety switch to the “NEUTRAL” position as shown below If you DID NOT connect a Neutral Wire: Move the safety switch to the “NO NEUTRAL” position as shown belowĥ. Install each Klever Switch to independent lighting loads by following the steps in the user installation manualĤ. Turn OFF your home’s circuit breakers and if you have metallic wall-boxes, place a strip of electrical tape over the screws on the side of your Klever Switch before turning the circuit breakers back ON.ģ. Choose the two Klever Switches that will control the same lightsĢ.
Independent Light Switches, No Neutral Wire Required:ġ. Read the following options and choose which one best fits for your home’s electrical installation: INSTALLATION Installation if a three-way electrical installation IS NOT present between the two switches you want to connect.
IMPORTANT: Make sure that the loads you want to control are connected to working lights. Please follow the instructions carefully. WARNING! Installing the Klever Switch involves high voltage wiring. If your Klever Switches have already been wired and installed, please jump directly to the Setup section below.
For example, two Klever Switches can be used in a three-way setup, so you can turn your lights on and off from the top and bottom of a staircase. The Kleverness three-way switch feature allows you to control any light from two different Klever Switches without any special wiring connections but also adapts to existing three-way setups that are being replaced with Kleverness. What is the Kleverness three-way switch feature and how is it different? Three-way switches are always used in pairs and include special wiring connections. A three-way switch is a type of light switch that allows you to control a light or other electrical fixture from two different locations in a room.
0 kommentar(er)
